Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
4-32 Trunk Digit Restriction
General Description
Use this Memory Block to specify per port the maximum number of digits that can be
dialed on any outside line.
Display
Tel
Port
No.
(01~C0)
Programming Procedures
1 Go off-line.
2 Press LK4 + CB to access the Memory Block.
3 Use the dial pad to change Setting Data for CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Related Programming.
Data
No.
Title
0 1 / 3 2 : D G R E S T = 0 0
T I M E D I S P L A Y
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Refer to Chapter 3 Advanced Applications.
1. Code Restriction must be assigned before this feature is used.
Default Values
00 (No Limit)
� Notes �
2. Trunk Digit Restriction applies to all CO/PBX lines.
3. Tie Line Code Restriction must be assigned before this feature works on Tie lines.
4. Telephone ports A0~C0 are ports 100~120.
Setting
Data
(00~99)
Telephone Mode
4
Submode
—
Data No.
32
PC Programming
�+BTT
___________________________________________________________________________________
Programming Manual 2 - 541