Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-10-22 Call by Call Incoming Type Selection
General Description
Use this Memory Block to specify the type of trunk for each Simulated Facility Group
(SFG).
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded
selection is the
CO DID
default.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK10 + JJBBto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Use the following to enter data:
�
JandLto move the cursor
D to select next RAB No.
4 Press G to write the data. The next SFG for Memory Block 1-10-20 is displayed. The SFG Memory Block 1-10-20~22
cycle is repeated until the data for SFG 16 is entered. RAB 1 is displayed for Memory Block 1-10-00.
5 Press E to go back on-line.
Related Programming
Data
SFG
01~16 Title
No.
0 1 / 2 2 : I N C O M D I D
T I M E D I S P L A Y
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
1-1-30 Route Advance Block Assignment
1-1-46~48 Access Code (1-, 2-, or 3-Digit) Assignment
1-10-00 Call by Call Type of Network ID Assignment
1-10-01 Call by Call ID Plan Assignment
1-10-02 Call by Call Type of Number Assignment
1-10-03 Call by Call Numbering Plan ID Assignment
1-10-04 Call by Call Network ID Assignment
Setting
Data
System Mode
1
Submode
10
Data No.
22
PC Programming
�+AY
___________________________________________________________________________________
Programming Manual 2 - 287