Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
B
E
G
Table 1-2 Multiline Terminal Keys Used for Programming
Key Description
This key is used to enter a pause, hyphen, asterisk or pound. To enter
an asterisk or pound:
B J + � =
B L + = #
B + A= A
B + B= B
B + C= C
The Message Waiting LED turns on and off afterJorLis pressed.
Used to exit the programming mode (go back on-line).
Used to write (save) data. After entering data, press G ; the data is
written into memory. The next Memory Block is displayed.
2.5.3 Entering Programming Mode
The following digital Multiline Terminals can be used to program the
system. Station ports 01 and 02 are automatically assigned as
programming stations.
DTP or DTH/DTR-8D-1 TEL
�
DTU-8D-2 TEL
�
DTP or DTH/DTR-16D-1 TEL
�
DTU-16D-2 TEL
�
DTP or DTH/DTR-32D-1 TEL
�
DTU-32D-2 TEL
�
Using the DTH-16LD -1 TEL to program is not
�
recommended.
To enter programming mode, the station must be idle (on-hook).
Perform the following procedure to go off-line.
1. Press A .
2. Press H .
___________________________________________________________________________________
1 - 8 Multiline Terminal Programming