Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
Programming Procedures (Continued)
3 Press the corresponding CO/PBX line key to change signal detect timeout for CO/PBX No.
Originating Side
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
Sending an Outgoing Signal
Receiving Acknowledgment Signal
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
1. When the acknowledgment signal is not received in a programmed time after an outgoing signal is sent to the
other system, a busy tone is sent to the telephone.
� Notes �
2. This Memory Block affects T1 channels assigned to Tie/DID lines.
___________________________________________________________________________________
Programming Manual 2 - 455
Time
Timeout when the
acknowledgment
signal is not received.