Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-8-01 SLT or Automated Attendant/DISA to
CPU PBR Selection
General Description
Use this Memory Block to specify whether the four Push Button Receiver (PBR)
circuits in the CPUI( )-U( ) ETU are used for Single Line Telephones or Automated
Attendant/Direct Inward System Access (DISA).
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
PBR 1
and 2
Data
No.
PBR 3
and 4
Programming Procedures
1 Go off-line.
2 Press LK1 + LK8 to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
The LED indication changes to indicate the data each time the CO/PBX line key is pressed.
CO/PBX
Line LED
Title
0 1 : P B R ( S L T / A A )
T I M E D I S P L A Y
Off On
Data Single Line Telephone A.A./DISA
4 Press G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press E to go back on-line.
The shaded area
indicates the default
setting.
� Notes �
Default not
assigned.
System Mode
1
Submode
8
Data No.
01
PC Programming
�+BTI
When LK1 and LK2 are assigned to Automated Attendant/DISA, a PBR( )-U( ) ETU must be installed in the
system when Single Line Telephones are used.
___________________________________________________________________________________
Programming Manual 2 - 207