Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-15-02 Common Signal Channel Assignment
General Description
Use this Memory Block to assign a T1 Trunk to be a Common Signaling Channel.
Display
Programming Procedures
1 Go off-line.
Data
No.
2 Press LK1 + LK15 + KB to access the Memory Block.
3 Use dial pad keys to enter Setting Data.
Use the following to enter data:
�
Jto move cursor left
Lto move cursor right
K~ Ito enter numeric data
4 Press G to write the data.
5 Press E to go back on-line.
Related Programming
Title
C-Channel
1~4
0 2 : C S C 1 = C O 0 0
T I M E D I S P L A Y
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
Setting
Data
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
Default Values:
___________________________________________________________________________________
Programming Manual 2 - 337
00
System Mode
1
Submode
15
Data No.
02
PC Programming
�+AW