Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
Display (R3000 or higher)
Data
No.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 +KEto access the Memory Block.
3 Use the dial pad to enter the Data Setting for Class 1.
Setting Data
00s~99s (e.g., 02s = 2s)
4 Press G to write the data and display the next Timer Class of Service.
5 Program the next Timer Class of Service or press E to go back on-line.
Related Programming
Title
M.B. Number Memory Block Name
Timer
Class
0 5 : S T A R T 1 = 0 2 s
T I M E D I S P L A Y
1-5-25 SMDR Valid Call Time Assignment
4-71 Station to Timer Class of Service (R3000 or higher)
1. This time is used for the features with functions described below:
� Notes �
Default Values
Class 1~4 = 02s
00s = No Limit
Elapsed Call Time: The time after dialing before the Elapsed Call Time is started and displayed on a Multiline
Terminal.
SMDR Start Time: The time needed after dialing before the SMDR Valid Call Time is started. Refer to Memory
Block 1-5-25 (SMDR Valid Call Time Assignment). For outgoing calls, both Elapsed Call Time and SMDR Valid
Call Time must elapse before a call record is generated.
2. Telephone ports 1 and 2 are in Station to Timer Class of Service, Class 1 by default. All other ports are in Station
to Timer Class of Service, Class 2 by default (R3000 or higher).
3. When a system is upgraded from R2500 or lower, the Start Time Selection is reset to the default value during
the upgrade process (R3000 or higher).
4. For copper trunks only. Not supported on digital trunks.
1~4
Setting
Data
___________________________________________________________________________________
2 - 10 Memory Blocks