Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
1-10-06 Call by Call Facility Coding Value
Assignment (Feature)
General Description
Use this Memory Block to specify the Facility Coding Value (Feature) for each Route
Advance Block (RAB). This setting data is sent in the FCV-F field of the NSF-IE
(Network Specific Facility Code-Information Element) when making outgoing calls.
Display
Programming Procedures
1 Go off-line.
Data
Rab
01~32 Title
No.
0 1 / 0 6 : F C V – F = 0 0
T I M E D I S P L A Y
2 Press LK1 + LK10 +JF to access the Memory Block.
3 Enter three or four digit data using the dial pad.
Setting
Data
�
�
Use the following to enter data:
JandLto move the cursor
K~Ito enter data
D to select next RAB No.
Setting Data:
PRT ETU SW1
Setting Setting Data Description
5ESS (AT&T)
00 Non-CBC Route Advance Block (None)
01~04 Reserved (Not Used)
05 Operator (Local Exchange)
06 Operator (Default-Common Carrier)
07~31 Reserved (Not Used)
4 Press G to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press E to go back on-line.
Default Values
All RABs 00
System Mode
1
Submode
10
Data No.
06
PC Programming
�+AY
___________________________________________________________________________________
Programming Manual 2 - 275