Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-24 Tie Line Incoming Interdigit Timeout
Selection
General Description
Use this Memory Block to specify the time, in seconds, that an address signal is
missing during the incoming call detection process before an error tone is returned to
the other system.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
∞
(No Limit)
Page 2
1s 2s 3s 4s 5s 6s 7s
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
8s 9s 10s 11s 12s 13s 14s 15s
Programming Procedures
1 Go off-line.
CO/PBX
No.
(01~64
Data
Setting
Page
Data
Title No.
0 1 / 2 4 : I N C O M 6 s | 1
T I M E D I S P L A Y
2 Press LK3 + G + BD to access the Memory Block.
3 Press the corresponding CO/PBX line key to change incoming interdigit timeout for CO/PBX No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
24
PC Programming
�+ALM
The shaded
selection is the
default.
___________________________________________________________________________________
2 - 452 Memory Blocks