Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
1-15-14 Centralized Day/Night Switching for
Main Office Assignment
General Description
Use this Memory Block to assign the Point Codes and the CCH Channel to control
remote systems for Centralized Day/Night Switching.
A CCH Channel of i can be assigned for K-CCIS over IP (R1500 or higher).
Display
Programming Procedures
1 Go off-line.
Data
No.
2 Press LK1 + LK15 + AD to access the Memory Block.
3 Use dial pad keys to enter Table number, CCH Channel, and Point Code.
Press Redial + 1 to assign i for K-CCIS over IP (R1500 or higher).
Use the following to enter data:
�
Jto move cursor left
Lto move cursor right
K~ Ito enter numeric data
Point code range is 00001~16367.
Tables 01~16 can be assigned.
4 Press G to write the data, and display the next Memory Block.
5 Repeat Steps 3 and 4 for each table. The next Memory Block is displayed.
6 Program the next Memory Block or press E to go back on-line.
Related Programming
Table
01~16
Point
Code
1 4 : T 0 1 : = 0
T I M E D I S P L A Y
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
CCH
Channel
1~4, i
1-15-01 Common Signal Channel Data Speed Assignment
Default Values:
All Tables Not Specified
System Mode
1
Submode
15
Data No.
14
PC Programming
�+AW
___________________________________________________________________________________
2 - 362 Memory Blocks