Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Document Revision 4 Electra Elite IPK
Programming Procedures
1 Go off-line.
2 Press LK1 + LK2 + CB to access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Data option.
� LK Off – Not Assigned
� LK Green – Block Assigned for IP Phone
� LK Red – Block not available for IP Phone
4 Press C to go to the next page.
Press A to return to the previous page.
5 Press G to write the data. The next Memory Block is displayed.
6 Program the next Memory Block or press E to go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-2-04 Call Arrival Key Block Assignment
1-2-21 PS Telephone Block Assignment
1-2-33 IP Telephone Block Assignment Allow/Deny Selection
4-07 Code Restriction Class Assignment (Day Mode)
4-08 Code Restriction Class Assignment (Night Mode)
4-40 LCR Class Selection
4-54 Enhanced 911 CESID to Station Table Assignment
4-56 SMDR Telephone Print Selection
4-67 IP Station Number Assignment
Notes �
�
1. The Electra Elite IPK Basic port package allows up to 30 IP Telephones to be installed using dedicated ports
73~104.
2. The maximum station port capacity for the Electra Elite IPK Expanded port package is reduced by the number of
IPC IP Telephones assigned by this Memory Block in groups of four.
3. The Electra Elite IPK Expanded port package allows a maximum of 120 ports to be shared by station ports (ESI,
SLI, OPX, FMS/VMS, etc.), Call Arrival Keys, PS Telephones, and IP Telephones. When 32 stations are used as
IP Telephones, 88 station ports remain for use by the Legacy system.
___________________________________________________________________________________
2 - 132 Memory Blocks