Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-02 Trunk Status Selection
Use this Memory Block to specify whether a CO/PBX line is used for call origination
and termination or termination only.
Display
Settings
CO/PBX
No.
(01~64)
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK8 The shaded
selection is the
OUT&IN IN
default.
Programming Procedures
1 Go off-line.
Data
No. Setting Data
Setting
0 1 / 0 2 : O U T & I N
T I M E D I S P L A Y
2 Press LK3 + G to access the Memory Block.
3 Press the corresponding CO/PBX Line Key to change the option.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
CO/PBX Line Mode
3
Submode
—
Data No.
02
PC Programming
�+BCT
___________________________________________________________________________________
2 - 426 Memory Blocks