Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
3-21 Tie Line Length of Wink Signal
Selection
General Description
Use this Memory Block to specify the time a wink pulse is sent to another system.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
30
Page 2
60 90 120 150 180 210 240
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
270 300 330 360 390 420 450 480
Programming Procedures
1 Go off-line.
CO/PBX
No.
(01~64)
0 1 / 2 1 : W I N K 1 8 0 | 1
2 Press LK3 + G + BA to access the Memory Block.
3 Press the corresponding CO/PBX line key to change wink-signal time for CO/PBX No.
Receiving Side
Data
Setting
Page
Data
Title No.
T I M E D I S P L A Y
Incoming Signal Detection
� Use the following to enter data:
Wink Pulse Sending
to move the cursor left
L to move the cursor right
J
to enter numeric data or CO/PBX No.
– OR –
K~I
D to go to the next assigned CO/PBX No.
C to go to the next page
A to go to the previous page
4 Press G to write the data and display the next Memory Block.
CO/PBX Line Mode
3
Submode
—
Data No.
21
PC Programming
�+ALM
The shaded
selection is the
default. Times
are in
milliseconds.
___________________________________________________________________________________
2 - 448 Memory Blocks
Time
DC Loop Supervision