Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
Related Programming
M.B. Number Memory Block Name
1-6-01 Attendant Add-On Console to Telephone Port Assignment
7-2 Telephone Type Assignment
1. When TEL is assigned to a line key, the red LED is used to indicate Station Status.
� Notes �
2. When a function (e. g., Message or Paging) that does not require a green LED is assigned to a 2-color LED key,
the green LED does not function.
3. Telephone number setting data for telephone sets is determined by the number of installed ESI(8)-U( ) ETUs.
4. Message Waiting and Attendant Station Outgoing Lockout cannot be assigned on the same console.
5. DSS/CO keys should be programmed on line keys 1~48 only.
6. The VM (Live Record) key with Live Record has seven features:
Feature No. Feature
00 Record Start
01 Record Pause/Restart
02 Record Erase
03 Record Finish
04 Record Erase/Restart
05 Pager
06 Record Confirmation
Each function can be assigned by dialing the Feature No. using the dial pad after pressing LK1 on page 3.
7. Digital Voice Mail Mailbox Number can be entered using two, three, or four digits of the Mailbox number on the
dial pad. This feature is used for Live Record addressing. The Live Record feature must be assigned also to a
line key on the console.
8. R3000 or higher is required to support Centralized BLF on the DSS Console. The Mail Box (Page 3, LK 2) key
on the Attendant Add-On Console is used to support the BLF of the remote stations across K-CCIS.
9. R4000 or higher is required to support Call Park Keys.
10. When the system is set for 10 Call Park Locations, 0~9 are used. When the system is set for 40 Call Park
Locations 00~39 are used to assign the Call Park keys. Refer to Memory Block 1-8-51 (Call Park Selection).
___________________________________________________________________________________
Programming Manual 2 - 187