Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
3-12 Trunk-to-MOH Trunk Assignment
General Description
Use this Memory Block to specify the music on hold source for each CO/PBX line.
Display
CO/PBX
No.
(01~64)
Programming Procedures
1 Go off-line.
2 Press LK3 + G +AB access the Memory Block.
3 Enter data for CO/PBX No. using the dial pad to assign the music selection.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Related Programming
Data
No.
Title
0 1 1 2 : H O L D C O 0 0
T I M E D I S P L A Y
M.B. Number Memory Block Name
1-4-17 Automated Attendant Delay Announcement Hold Tone Selection
1-8-09 Music on Hold Pattern Selection
1-8-31 Hold Tone Source Assignment
1-8-32 Hold Internal Tone Volume Selection
3-11 CO External Source Selection
4-66 MOH or Ring Back Tone Selection
Setting
Data
Default Values
1. When set to 00, the CO gets Music on Hold from the MOH jack on the side of the cabinet.
� Notes �
CO/PBX Line Mode
3
Submode
—
Data No.
12
PC Programming
�+BCT
00 = Not Assigned for CO/PBX No. 01~64
2. When Memory Block 1-8-31 (Hold Tone Source Assignment) is set to INT, this Memory Block is not used.
___________________________________________________________________________________
Programming Manual 2 - 435