Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-44 Caller ID Preset Dial Outgoing CO
Selection
General Description
Use this Memory Block to assign the Trunk group, Route Advanced group, or Closed
Numbering group that is seized for ANI/Caller ID Outgoing Calls. Use the ANI/Caller
ID Scroll key to access the ANI/Caller ID to be called.
Display
Tel
Port
No.
(01~C0)
Programming Procedures
1 Go off-line.
Data
No.
0 1 / 4 4 :
Setting
Data
T I M E D I S P L A Y
2 Press LK4 + DD to access the Memory Block.
3 Use the dial pad to enter Trunk Group, Route Advance group, or Closed
Numbering group Access Code to seize for ANI/Caller ID outgoing calls for
Tel Port No.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Default Value
Not specified
1. Setting Data is Access Code Assignment in Memory Blocks 1-1-46, 47, 48 [Access Code (1-Digit, 2-Digit, or
3-Digit) Assignment]. For example: Dial 9 (101) → Trunk Group 1.
� Notes �
2. Assign the ANI/Caller ID Scroll key using Memory Blocks 2-06 (Line Key Selection for Tenant Mode) or 4-12
(Line Key Selection for Telephone Mode).
3. Telephone ports A0~C0 are ports 100~120. Use redial +1 for A, redial +2 for B, and redial +3 for C.
Telephone Mode
4
Submode
—
Data No.
44
PC Programming
�+AI
___________________________________________________________________________________
2 - 558 Memory Blocks