Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-8-08 Class of Service (Station) Feature Selection 2 (Page 6, LK 2)
1-15-00 K-CCIS Main/Remote Office Selection
1-15-01 Common Signal Channel Data Speed Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralized Billing Allow/Deny Selection
1-15-12 Centralized Billing – Point Code of Center Office Assignment
1-15-13 Centralized Day/Night Switching for Remote Office Assignment
1-15-14 Centralized Day/Night Switching for Main Office Assignment
1-15-15 Centralized BLF Send Extension Number Assignment
1-15-17 Centralized BLF Send Time Assignment
1-15-18 Centralized BLF Display Extension Number Assignment
3-70 CIC Number Assignment
4-12 Line Key Selection for Telephone Mode
4-17 Station to Class of Service Feature Assignment
5-05 Common Signaling Channel Route Assignment
1. The Send Group Number selected by the Line Key is the Group number assigned in Memory Block 1-15-15
(Centralized BLF Send Point Code Assignment).
� Notes �
2. Up to 120 Extension Numbers (entries in the table) can be assigned to send BLF messages. With each assigned
extension number, up to eight destination offices can be selected until 240 extension numbers are assigned.
3. A maximum of 240 total sending Extension Numbers (BLF messages) can be assigned. If 30 Extension
Numbers (entries in the table) are assigned with each set for all eight groups (systems), the 240 limit is reached
and no more Extension Numbers can be entered.
4. When a Send Group (Point Code) is cleared in Memory Block 1-15-15, it is also cleared in this Memory Block.
___________________________________________________________________________________
Programming Manual 2 - 367