Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
3-03 Trunk-to-Trunk Group Assignment
General Description
Use this Memory Block to assign a Trunk Group Number (01~32) to each CO/PBX
line.
Display
CO/PBX
No.
Programming Procedures
1 Go off-line.
Data
(01~64) Title
No.
0 1 / 0 3 : T R K G P = 0 1
T I M E D I S P L A Y
Group
Trunk
(01~32)
No.
2 Press LK3 + G + KCto access the Memory Block.
3 Enter data for CO/PBX No. 01 using the dial pad to change the Trunk Group
number.
Use the following enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or CO/PBX No.
– OR –
D to go to the next assigned CO/PBX No.
Trunk Group No:
�
00: Not Set
01~32: Trunk Group 01~32
4 Press G to write the data and display the next Memory Block.
5 Program the next Memory Block or press E to go back on-line.
Default Values
� Notes �
CO/PBX Line Mode
3
Submode
—
Data No.
03
PC Programming
�+BCT
CO/PBX lines (01~08) in Trunk Group 01
CO/PBX lines (09~64) in Trunk Group 00
All Tie lines in Trunk Group 02
All DID lines Trunk Group 00
1. When a Trunk group Access Code is dialed, an idle CO line is selected automatically and seized from the same
Trunk group dialed (the CO line of either same tenant or another tenant can be seized).
2. By specifying the priority order, up to four routes (Trunk groups) can be selected in Memory Block 1-1-30 (Route
Advance Block Assignment). Idle CO lines are selected and seized in this sequence.
3. When LCR is installed, Local Trunks should be assigned to Trunk Group 1. When a number is dialed that
bypasses LCR, the system accesses Trunk Group 1 and dials the number.
___________________________________________________________________________________
Programming Manual 2 - 427