Electra Elite IPK Programming Manual - Southwestern Telephone ...

___________________________________________________________________________________
Electra Elite IPK Document Revision 4
Time
Tie Line Length of
Delay Signal
Selection
Tie Line Incoming
Interdigit Timeout
Selection
Tie Line Wink/Delay
Signal Detect
Timeout Selection
Disconnect
Recognition Time
Selection
Automatic Release
Signal Detection
Selection
DIT/ANA Delay
Answer Time
Selection
Memory
Block
Table A-1 Function Time Chart (Continued)
Definition
3-22 The time (milliseconds) a delay
pulse is sent to another system.
3-24 The maximum time an address
signal is missing during
incoming call detection before
an error tone is returned to the
other system.
3-25 The maximum time for
receiving an acknowledgment
signal from a distant system
before sending a busy tone.
3-33 The minimum time (seconds)
before a disconnected circuit
can be accessed again.
3-40 The Signal detection time
(milliseconds) for CO/PBX line
release after a disconnect
signal is received from the
distant CO or PBX.
3-61* The time an incoming CO/PBX
call rings before changing to a
DIT/ANA call.
0 300 4500
1s 6s ∞
1s 7s ∞
0 0.3 1.5
0 350 ∞
___________________________________________________________________________________
Programming Manual A - 7
0s
00s
(No Time)
Value
Minimum Default Maximum
* With R3000 or higher, these Memory Blocks have changes in Minimum, Default, or Maximum values
that are indicated by bold figures
0s
00s
60s
99s