Electra Elite IPK Programming Manual - Southwestern Telephone ...

Electra Elite IPK Document Revision 4
___________________________________________________________________________________
BRI:
� Notes �
1. When this Memory Block is set to No, the station placing an outgoing call does not present the programmed
number in Memory Block 3-52 assigned for the BRI Trunks. The Network presents Restricted for the Caller ID
information.
2. When this Memory Block is set to YES, the station placing an outgoing call presents the programmed number in
Memory Block 3-52 assigned for the BRI Trunks. The Network presents the programmed number as Caller ID.
PRI:
1. For ISDN-PRI Calling Party Number (CPN) Presentation from Station, PRT firmware Version 3.50 or higher is
required.
2. When this Memory Block is set to No, and ISDN-PRI is used in CO Mode in Memory Block 3-91, the programmed
number in Memory Block 3-52 is not presented as Caller ID. The Network presents Restricted for the Caller ID
information.
3. When this Memory Block is set to YES, and ISDN-PRI is used in CO Mode in Memory Block 3-91, the
programmed number in Memory Block 3-52 is presented as Caller ID. The Network presents the programmed
number as Caller ID.
4. When this Memory Block is set to No, and ISDN-PRI is used in DID Mode in Memory Block 3-91, the
programmed number in Memory Block 3-52 is not presented as Caller ID.
5. When this Memory Block is set to YES, and ISDN-PRI is used in DID Mode in Memory Block 3-91, the
programmed number in Memory Block 4-62 is presented as Caller ID. The Network presents the programmed
number as Caller ID.
___________________________________________________________________________________
Programming Manual 2 - 561