Electra Elite IPK Programming Manual - Southwestern Telephone ...

Document Revision 4 Electra Elite IPK
___________________________________________________________________________________
4-13 CO/PBX Busy Forward Station
Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call
terminates at a busy station.
Display
Programming Procedures
1 Go off-line.
Tel
Port
No.
(01~C0)
Data
Title
No.
2 Press LK4 + AC to access the Memory Block.
3 Use dial pad to change data.
Use the following to enter data:
�
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data or Tel Port No.
– OR –
D to go to next assigned Tel Port No.
B + Ato enter A for Port Numbers 100~109.
B + Bto enter B for Port Numbers 110~119
B + Cto enter C for Port Number 120
Setting Data: Port No. 01 ~ 96
�
4 Press G to write the data and display Forward No. 2.
5 Enter second transfer Port No.
Forward
No.
6 Press G to write the data and display the next Memory Block.
7 Program the next Memory Block or press E to go back on-line.
Default Values
Not specified
1. When the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a
second specified station (Forward 2).
� Notes �
2. When all three stations are busy, the first station rings.
1/2
0 1 / 1 3 : F W D 1 =
T I M E D I S P L A Y
Setting
Data
3. Telephone ports A0~C0 are ports 100~120.
Telephone Mode
4
Submode
—
Data No.
13
PC Programming
�+BTT
___________________________________________________________________________________
2 - 520 Memory Blocks