10.07.2015 Views

Scientific Papers Series B Horticulture

Scientific Papers Series B Horticulture

Scientific Papers Series B Horticulture

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

efore it is printed using the main dough Thebottom of the mold pot gived the main dough.After the coating dough is evenly, then coveredagain with the main dough that it mixed withthe water as the main ingredient pot. After itspread evenly, sprinkle the main dough withoutwater, to strengthen those pot. When the maindough is evenly distributed on the mold, wesprinkle again with coating dough to give colorto the inside of the pot.After everything is evenly distributed, theinside of the pot must be be smooth usingsmoother scoop. So do with the mouth of thepot, it also must be smooth using smootherscoop. The thickness of the pot that will beproduced is about 5cm. The pot mold left forabout 5minutes, then the pot mold reversedslowly to remove the pot from the mold. Thebond rubbers is removed one by one from themold, then the pot is placed in the shade toavoid the direct sunlight.The Maintenance ProcessMove the vetiverwaste pot that printed to the protected placefrom the sunfor for 12 to 24 hours, until theflower pot come tobe hard.The placement of flower pot in the sheltershould be up and squeezed between the headand the head, so do the leg and the leg offlower pot, so that the surface are ot broken andthe placement of the bottom side of the vetiverwaste waste should be given as the base. Theroom should be covered and kept holding theair circulation so that the pot does not strickendirect of the sunlight. The cooling processshould be performed by air drying or ratherdried. This Drying is carried out for three dayso rperceived vetiver waste pot is dry.Figure 2. Manufacture of vetiver waste process (1) Vetiver waste is cut in to small pieces (2) Vetiver waste is mixedwith cement and sand (3) Stir it so that the dough distribute evenly (5) The printing dan (5) And that is teh eco-friendlyvetiver waste pot.The Results of Seepage Test and PressingTest1. The Results of Seepage TestThe seepagetest is did on the pot by putting water intothe pot until it full during 24 hours. Whenthe seepage test, the pot with normalmaterial and the vetiver waste pot arefulfilled with the same water during 24hours. Start at 08.00 a.m on May 5 th 2012until 08.00 a.m on May 6 th 2012.Table 1. The Seepage Test Result of Vetiver Waste Pot and the Normal PotThe Reducing Water (cm)The RepetitionVetiver Waste PotNormal Pot1 3,50 7,502 3,50 3,503 3,50 3,504 3,75 3,505 3,50 4,506 3,50 3,507 3,50 3,50The Average 3,54 4,21The vetiver waste can absorb the water 3.54 cmin average and the normal pot can absorb thewater 4.21 cm. This indicates both vetiverwaste pot and normal pot able to meet one ofthe requirements of good pots that can absorbthe water.439

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!