Ipswitch WhatsUp Gold User Guide - Ipswitch Documentation Server

Ipswitch WhatsUp Gold User Guide
Software Bypass
Synchronized command is in progress
Tip: Use the list's vertical scroll bar to browse the output states.
Monitor the following abnormal conditions. Select the abnormal condition(s) on
which you want to be alerted. Refer to the APC UPS documentation for more
information about the abnormal conditions. By default, all of the abnormal conditions
are selected for use in the monitor.
Backfeed Protection Relay
Battery Failure
Battery Voltage High
Bypass Contactor Stuck in Bypass Condition
Bypass Contactor Stuck in On-Line Condition
Bypass not in Range, Either Frequency or Voltage
Extended Run Frame Fault
IIC Inter-Module Communication Failure
In Bypass due to an Internal Fault
In Bypass due to an Overload
In Maintenance Bypass
Input Circuit Braker Tripped Open
Load (kVA) Alarm Threshold Violation
Main Intelligence Module Failure
No Batteries Installed
No Working Power Modules
Output Voltage out of Range
Power Module Failure
Redundancy Below Alarm Threshold
Redundancy Lost
Redundant Intelligence Module Failure
Redundant Intelligent Module in Control
Runtime Below Alarm Threshold
Site Wiring Fault
System Level Fan Failure
UPS Not Synchronized
325