Ipswitch WhatsUp Gold User Guide - Ipswitch Documentation Server

Ipswitch WhatsUp Gold User Guide
Monitor. The configured monitors of the selected type. These are the monitors used
to determine if the measured parameters have dropped below or exceeded threshold
limits.
Note: When you select Global Monitors, this list is populated with custom performance
monitors currently configured in the Performance Monitor Library (on page 247). When you
select Device Specific Monitors, this list is populated with custom performance monitors
currently configured for specific devices.
Threshold. Select and enter the desired threshold criteria variables and values. The
default threshold is configured to alert when the custom performance monitor
average value exceeds 10 for 30 minutes.
Devices to Monitor. Click Select to choose the devices to which the threshold
applies. By default, the threshold applies to all devices where the applicable monitor
is enabled.
Notification. Select the notification policy to apply to this threshold. This policy
begins sending notifications when an item is outside the configured threshold limits.
If you do not see an appropriate threshold policy, or if the list is empty, click browse
(...) to open the Notification Policy dialog and configure a new policy.
Note: Notification policies are optional for most thresholds. If you do not select a notification
policy, no notifications are generated for the threshold, but a dashboard report listing the
out of threshold items still appears on the Alert Center Home page.
Threshold Check. Enter a value for the threshold check interval, or the interval at
which the Alert Center checks the WhatsUp Gold database to see if there are items
that are outside the threshold parameters.
Select Automatically resolve items no longer out of threshold to have Alert Center
automatically resolve items when they go back inside the parameters of the
threshold.
Note: Configure the threshold check interval for a longer time than the sampling interval for
thresholds relating to trends, such as percent utilization. Configure it for a time the same as
(or similar to) the sampling interval when configuring a threshold for a health check.
Avoid setting the threshold check interval to a very short time as this can degrade system
performance. In general, setting the threshold check interval to less than five minutes is
inadvisable.
6 Click OK to save the threshold settings.
757