Optivity Telephony Manager: System Administration - BT Business

100 Common services
4 In the Contact Information box, fill in the contact name and related information. Click
Apply.
5 To add a new system to this site:
a. Click Add System.
553-3001-330 Standard 3.00 August 2005
b. Follow the instructions for “Adding a system” on page 107, and “Adding a
Generic system or device” on page 142.
6 When you have finished entering Site information, click one of the following buttons
to add the site to the Navigator tree:
OK adds the site and closes the property sheet.
Apply adds the site and leaves the property sheet open, allowing you to add
another system to this site. Repeat step 5 to add another system.
Cancel closes the dialog box without adding the site.
Help opens up the Help file for Navigator.
Setting up a system to work with OTM
Follow this procedure to set up a system.
Procedure 4
Setting up a system
1 Verify that the system has the following system configuration:
The appropriate release, configured with the appropriate packages
48 MB or greater of memory
For Ethernet communications:
— X11 Release 22 or later
— IOP cards (Part number NT6D63BA or later),
IOP/CMDU cards (Part number NT5D20BA or later) (not applicable to
Meridian 1 PBX 11C Cabinet systems), Release 22, or
IODU/C cards (Part number NT5D61AB or later)
— One or two Ethernet AUI cables (Part number NT7D90DA or later). You
attach one cable to each IOP, IOP/CMDU, or IODU/C.
— For 11C, an NTDK27AA Ethernet cable
2 For Ethernet networks, you need the following:
One or two Ethernet transceivers (different types for 10BaseT and 10Base2
cabling): attach one transceiver to each AUI cable