Optivity Telephony Manager: System Administration - BT Business

Common services 107
Adding a system
You can use STAT ROUTE to see if the route was successfully enabled.
If you are using PPP, use the default addresses unless there is an address
conflict. If a conflict exists, obtain a new IP address from your network
administrator and configure this address.
>LD 117
>NEW HOST LOCAL_PPP 47.0.0.2
>CHG PPP LOCAL LOCAL_PPP M1ACTIVEIP
>LD 117
>NEW HOST REMOTE_PPP 47.0.0.3
>CHG PPP REMOTE REMOTE_PPP M1ACTIVEIP
After you perform a series of NEW, OUT, CHG commands, type
>UPDATE DBS
to clean up the database before you get out of LD 117.
Use Overlay 137 to verify the IP address:
>LD 137 (Note: Overlay 137 prompt is “.”)
.DIS ELNK (disable Ethernet interface)
.ENL ELNK (enable Ethernet interface)
.STAT ELNK (verify IP address)
If the STAT ELNK command displays the correct IP address, your IP address
configuration is done. Otherwise, you must INIT the system.
End of Procedure
Pre-Release 2.0 CS 1000 systems that were added in an earlier version of OTM cannot
be converted to a Communication Server 1000 Release 3.0\4.0. You must delete the
pre-Release 2.0 system and add a new Communication Server 1000 Release 3.0\4.0
system.
You can add as many as 3000 sites to OTM and 256 systems (including non-CS 1000
systems) to a site. You must have administrator privileges to add a system.
Refer to Geographic Redundancy 553-3001-307 for more information on the
Geographic Redundancy (GR) feature in OTM.
Optivity Telephony Manager System Administration