SuperH (SH) 64-bit RISC Series SH-5 System Architecture, Volume ...

PRELIMINARY DATA
58 Debug event actions
DM.WP_nx_ACTION
where
n= {IA/OA/IV},
x = channel ID (relative to N)
Field Bits Size Volatile? Synopsis Type
ACTION_TRIG_
OUT
16 1 — Trigger out enable RW
Operation
When read
When written
HARD reset
Enables or disables generation of a trigger out message for the
WP channel. The effect of this on the DM_TROUT_N pin is
determined by the programming of the DM.TRCTL register. See
Section 1.8.10: DM.TRCTL (trace/trigger register) on page 97.
Value - Description
0: The DM_TROUT_N pin is unaffected by hits on this WP
channel.
1: If DM.TRCTL.DM_TRIG_OUT_MODE == 0b001, then an
active-low pulse is produced on the DM_TROUT_N pin each time
a hit occurs on this WP channel (see Section
1.8.10: DM.TRCTL (trace/trigger register) on page 97). If
DM.TRCTL.DM_TRIG_OUT_MODE has any other value, hits on
this WP channel have no effect on the DM_TROUT_N pin.
Returns current value
Updates value
Undefined
OA_MATCH 17 1 — OA data match enable RW
Operation
When read
When written
This field applies only to OA watchpoints. It determines whether
DM chain latch, trace generation and interrupt actions are
dependent on a successful OA data match.
Value - Description
0: data match function is not enabled.
1: data match function is enabled.
D R A FT
Returns current value
Updates value
HARD reset
Undefined
Table 19: DM.WP_{IA/OA/IV}x_ACTION register definition
SuperH, Inc.
SH-5 System Architecture, Volume 3: Debug 05-SA-10003 v1.0