SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
1. Pressure-Seal Joining Procedure for Stainless Steel tube fitting. Qualify operators
according to training provided by Swagelok Company.
I. ASME Compliance:
1. Comply with ASME B31.3, "Process Piping," Normal Service Category, for “highpressure”
compressed-air piping.
2. Comply with ASME B31.3, "Process Piping," Normal Service Category, for “Instrument
Air” compressed-air piping.
3. Comply with ASME B31.3, Normal Service Category, as applicable, for materials, products,
and installation.
4. Safety Valves: ASME Boiler and Pressure Vessel Code: Section VIII, Division 1. Safety
valves shall bear the appropriate ASME label.
5. Pressure Vessels: ASME Boiler and Pressure Vessel Code: Section VIII, Division 1.
Pressure vessels shall bear the appropriate ASME label.
6. Flange set-up, alignment, bolt/stud installation and material requirements: comply with
ASME PCC-1-2010.
J. Steel Support Welding: Qualify processes and operators according to AWS D1.1/D1.1M,
"Structural Welding Code – Steel," and Section 055000, Metal Fabrications. Perform 100%
visual examination of final weld joints for piping supports, anchors, and all other structural
welds shall be in accordance with AWS D1.1 and D1.6 as applicable for statically loaded
structures.
K. Testing Agency Qualifications: An independent testing agency, with the experience and
capability to conduct the piping testing indicated, that is an NRTL as defined by OSHA in
29 CFR 1910.7, and that is acceptable to the Buyer.
L. Electrical Components, Devices, and Accessories: Listed and labeled as defined in NFPA 70,
Article 100, by a testing agency acceptable to the Buyer, and marked for intended use.
M. All items and processes are subject to review, inspection, or surveillance by the Buyer's Quality
Assurance or Engineering Representatives at the Vendor's facility or the Vendor's subcontractor
facility.
N. Hold, Witness, and Verification points shall be identified in the Fabrication, Inspection and Test
Plan. Prerequisites to verification points: Ensure that personnel have completed inspections and
approved portions of work in accordance with specification requirements before notifying
Buyer.
O. Seller shall control fabrication, assembly, inspection, testing, and related activities, performed in
shops and at worksite, in accordance with Fabrication, Inspecting and Test Plan.
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221513 - 6