SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
C. Mount equipment level and plumb.
D. Identify components according to Division 26 Section "Identification for Electrical Systems."
3.2 CONNECTIONS
A. Ground equipment according to Division 26 Section "Grounding and Bonding for Electrical
Systems."
B. Connect wiring according to Division 26 Section "Low-Voltage Electrical Power Conductors
and Cables."
C. Provide signal and alarm cabling for each radiation detection instrument per manufacturer
instructions and design drawings. Connect wiring according to Division 26 Section "Control-
Voltage Electrical Power Cables."
3.3 FIELD QUALITY CONTROL
A. Manufacturer's Field Service: Engage a factory-authorized service representative to inspect
field-assembled components and equipment installation and supervise pretesting, testing, and
adjusting of equipment.
B. Inspection: Verify that units are properly installed, connected, and labeled, and that
interconnecting wires and terminals are identified.
C. Operational Tests: Perform operational system tests to verify that system complies with
Specifications. Include all modes of system operation. Test equipment for proper operation in
all functional modes.
D. Remove and replace malfunctioning units and retest as specified above.
E. Record test results for each piece of equipment.
F. Retest: Correct deficiencies identified by tests and observations and retest until specified
requirements are met.
END OF SECTION 283233
Contract 44577 KW Annex – Rev. D 44577-CSI-SPEC-001 283233 - 3