SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
SECTION 400527 - PIPING AND TUBING INSPECTION CHECKLIST
PART 1 GENERAL
1.1 SECTION INCLUDES
A. Inspection of piping and tubing installations per design documents
B. Inspection of installation workmanship
C. Leak Testing
1.2 QUALITY ASSURANCE AND TESTING
A. Perform inspections and testing in accordance with Division 22 Sections “Nitrogen Gas
Piping”, and “General-Service Compressed Air Piping”, and Division 40 Sections,
“Process Plant Non-Potable Water Pipe (Modified for IXM)” and “Compression Fittings
on Copper and Stainless Steel Tubing”.
B. Quality Assurance Program
PART 2 PRODUCTS
Not used.
PART 3 EXECUTION
1. For all work, the fabricator is required to develop and implement a documented
quality assurance (QA) program which complies with the Contractor Requirements
Document (CRD) of DOE Order 414.1 (latest).
2. The fabricator is responsible for maintaining quality and shall perform in-process
and final inspection on his work as required herein. The fabricator must comply
with all applicable federal, state, or local codes.
3.1 INSPECTION ATTRIBUTES
A. General:
1. Approved design documents present.
2. Code to which it was designed identified (e.g., UPC, applicable ASME B31 code).
3. Design followed:
a. Required materials used (metal, polymer, schedule, markings per material
standard on tube, pipe, and fittings).
b. No counterfeit materials.
4. Routing layout, configuration.
5. Elevations (if elevation is critical).
6. Slope (if slope is critical).
Contract 44577 KW Annex – Rev. D 44577-CSI-SPEC-001 400527-1