SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
3.9 APPLICABLE PIPE CODES
PIPING CODE: S-2 IXM Water Piping (Specification Section 402319)
Design Pressure 125 psig
Test Pressure 188 psig
Operating Temperature
Inspection and Test
Method
Sizes 1/2" NPS and larger
Pipe
Environmental Extremes: -27°F to 110°F
Normal Operating Extremes: 65°F to 80°F (Note 1)
Welded Joints: In-Process Visual Weld Inspection
Hydrostatic testing at 150% of Design Pressure for all tubing and piping
ASTM A 312, Grade TP 304L, seamless, ASME B31.3, Process Piping Category
"Normal Fluid Service"
Wall Thickness Schedule 40S or as stated on fabrication drawing
Fittings
Cam-Lock Connectors
Flanges
Bolts/Nuts
Gaskets
Valves
ASTM A 403, Class WP-S 304L, butt welding in accordance with ASME
B16.9, wall thickness to match pipe. Corrosion allowance = 0.03-in.
Bends: Formed pipe bends having minimum center-line bend radius of 5 x
pipe nominal outside diameter.
Quick Disconnects: Autolok TM quick couplings, made by the OPW Company,
300 Series SST, threaded or welded as indicated on fabrication drawings.
Staubli HCB28 series, size and type as specified on the fabrication drawings.
Class 150, ASTM A 182, Grade F 304L forged, raised face weld neck, in
accordance with ASME B16.5 or as specified on drawing.
ASTM A 193 or ASTM A 320 any type of grade B8 and having hex nuts in
accordance with ASTM A 194 any type of Grade 8. It is preferred to have
either the bolt as grade B8S/B8SA or the nut as grade 85/85A to minimize
potential for galling of mated components.
Garlock "BLUE-GARD" 3000, 1/8-inch thick compressed gaskets with dimensions
conforming to ASME B1 6.21 Table 1-5
ASME B16.34, ball or plug type valve, stainless steel body, stainless steel
ball, flanged or butt weld ends, UHMWPE seats. Manual locking handle.
Note:
1) Based on 50°F minimum basin water temperature and 80°F summer inside HVAC design temperatures.
2) Standards referenced above shall be used unless approved by buyer.
3) AUTOLOK is a registered trademark of Delaware Capital Formation, Inc., Wilmington, Delaware.
END OF SECTION 402319
Contract 44577 KW Annex – Rev E. 44577-CSI-SPEC-001 402319-27