SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
1. Traceability to Buyer Contract number.
2. Description of items to fabricate/test/inspect.
3. Sequential fabrication/process steps.
4. Sequential points for inspection and tests to be performed during processing.
5. Methods/procedures to be used for performance of inspection, test, and/or fabrication including:
a. Method used to control material,
b. Method used to control filler materials,
c. Method used to verify the dimensional accuracy of the fabrication,
d. Method used to segregate tools used on fabrication of stainless steel from tools
used on carbon steel,
e. Weld procedures used for production welding.
6. Characteristic or attribute to be evaluated and acceptance criteria.
7. Report form to use.
8. Specific codes/standards requirements as specified by procurement documents.
9. Sampling plan for final characteristics (e.g. Quality Level, Lot size, inspection level,
etc.).
10. Fabrication procedures to use to perform the work.
11. Pneumatic Test Procedures.
12. The Buyer may perform oversight of fabrication and inspections to verify compliance to
requirements. Vendor shall notify the Buyer for verifications required in the Statement of
Work and/or as identified in the fabrication inspection and test plan.
B. Cleaning of piping: If manufacturer cleaned and capped fittings or piping are not available or if
pre-cleaned fittings or tubing must be re-cleaned because of exposure, have supplier or separate
agency acceptable to the Buyer.
1. Clean piping and fittings, valves, gages, and other components of oil, grease, and other
readily oxidizable materials.
2. Wash piping spools and components in hot, alkaline-cleaner-water solution of sodium
carbonate or trisodium phosphate in proportion of 1 lb (0.453 kg) of chemical to 3 gal.
(11.3 L) of water.
3. Scrub to ensure complete cleaning.
4. Rinse with clean, hot water to remove cleaning solution.
5. Prior to fit-up and welding, piping shall be visually checked for cleanliness. If examination
reveals rust, loose mill scale, or foreign matter, pipes shall be blown out with dry,
Contract 44577 KW Annex - Rev. E 44577-CSI-SPEC-001 226313 - 24