SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
6. NPS 1-1/2: 10 feet with 3/8-inch rod.
7. NPS 2: 11 feet with 3/8-inch rod.
I. Install supports for vertical piping every 10 feet.
3.6 FASTENERS
A. Graded fasteners shall be carefully controlled as defined in Section 014000, Quality Assurance
and Control, as applicable.
B. Seller shall establish the bolt torque requirements for all bolted structural connections in accordance
with Section 055000, Metal Fabrications.
C. Flange bolt torque values shall be per gasket manufacturer recommendation not to exceed 75%
of bolt allowable yield strength as defined in the applicable ASTM standard and using appropriate
bolt torque patterns as shown in ASME PCC-1-2010, Appendix F.
3.7 LABELING AND IDENTIFICATION
A. Install identifying labels and devices for piping, valves, and specialties. Label piping system in
accordance with Section 220553, Identification for Plumbing Piping and Equipment.
3.8 FIELD QUALITY CONTROL
A. Testing Agency: Buyer will engage qualified testing agency to perform field tests and
inspections of piping and prepare test reports.
B. Perform field tests and inspections of piping and prepare test reports.
C. Tests and Inspections:
1. Piping Testing Coordination: Perform tests, inspections, verifications, and certification
of piping systems concurrently with tests, inspections, and certification of interfacing
systems.
2. Inspect Pressure or flow regulators for proper operation.
3. Preparation: Perform the following Installer tests:
a. Initial blow down.
b. Initial pressure test.
c. Standing pressure test for positive pressure piping.
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221513 - 28