SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
3.6 FASTENERS
A. Graded fasteners shall be carefully controlled as defined in Section 014000, Quality Assurance
and Control, as applicable.
B. Seller shall establish the bolt torque requirements for all bolted structural connections in accordance
with Section 055000, Metal Fabrications.
C. Flange bolt torque values shall be per gasket manufacturer recommendation not to exceed 75% of
bolt allowable yield strength as defined in the applicable ASTM standard and using appropriate
bolt torque patterns as shown in ASME PCC-1-2010, Appendix F.
3.7 LABELING AND IDENTIFICATION
A. Install identifying labels and devices for piping, valves, and specialties. Label piping system in
accordance with Section 220553, Identification for Plumbing Piping and Equipment.
3.8 FIELD QUALITY CONTROL
A. Testing Agency: Buyer will engage qualified testing agency to perform field tests and inspections
of piping and prepare test reports.
B. Perform field tests and inspections of piping and prepare test reports.
C. Tests and Inspections:
1. Piping Testing Coordination: Perform tests, inspections, verifications, and certification
of piping systems concurrently with tests, inspections, and certification of interfacing
systems.
2. Inspect Pressure or flow regulators for proper operation.
3. Preparation: Perform the following Installer tests:
a. Initial blow down.
b. Initial pressure test.
c. Piping purge test.
d. Standing pressure test for positive pressure piping.
4. Piping Pressure-Leak Tests: Test new and modified parts of existing piping. Cap and fill
piping with oil-free, dry nitrogen to pressure of 110% above system design pressure.
Isolate test source and let stand for four hours to equalize temperature. Refill system, if
required, to test pressure; hold for two hours with no drop in pressure. Utilize a bubble
forming solution for indication of any possible leaks.
Contract 44577 KW Annex - Rev. E 44577-CSI-SPEC-001 431510 - 25