SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
D. Operation and Maintenance Data: For compressed-air equipment to include off normal, normal
operation, and maintenance manuals.
1.4 QUALITY ASSURANCE
A. Work identified in this section shall be done under a Quality Assurance program in accordance
with ASME NQA-1, as approved by the Owner and described in Section 014000, Quality
Assurance and Control.
B. The highest functional classification for the scope of this Specification section is classified as
General Service.
C. Electrical Components, Devices, and Accessories: Listed and labeled as defined in NFPA 70,
by a qualified testing agency, and marked for intended location and application.
D. ASME Compliance: Fabricate and label air compressor coolant tank, air receivers and air dryer
towers to comply with ASME Boiler and Pressure Vessel Code, Section VIII, Division 1.
Submit ASME U1 Data reports for each vessel.
E. The assembled units and optional equipment shall be factory tested prior to shipment.
1.5 DEFINITIONS
A. Refer to Section 011100, Summary of Work, for definition of general requirements that apply to
all specification sections prepared for this Project.
B. Specific definition applicable to this section include:
1. Actual Air: Air supplied or delivered from air compressors. Flow rate is compressed air
measured in acfm.
2. Low Voltage: As defined in NFPA 70 for circuits and equipment operating at less than
50 V or for remote-control, signaling power-limited circuits.
3. Standard Air: Free air at 68 deg F and 1 atmosphere (14.696 psia) before compression or
expansion and measured in scfm.
4. Buyer: the contractor responsible for managing the design, procurement, and construction
of the K-West Basin Modification Annex Project.
5. Seller: Contracted fabricator, Seller, or subcontractor performing work to the contract
drawings, data sheets, and technical specifications.
6. Certificate of Conformance: A document signed or otherwise authenticated by an
authorized individual certifying the degree to which items or services meet specified
requirements.
7. MSDS: Material Safety Data Sheet
1.6 PERFORMANCE REQUIREMENTS
A. Delegated Design: Design compressed-air equipment mounting, including comprehensive
engineering analysis by a qualified professional engineer, using performance requirements and
design criteria indicated.
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221519 - 2