SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
2. Portable Feed-Through Accessory: Two-terminal, dead-front junction arranged for
removable mounting on accessory stand of stationary terminal junction.
3. Grounding Kit: Jumpered elbows, portable feed-through accessory units, protective caps,
test rods suitable for concurrently grounding three phases of feeders, and carrying case.
4. Standoff Insulator: Portable, single dead-front terminal for removable mounting on
accessory stand of stationary terminal junction. Insulators suitable for fully insulated
isolation of energized cable-elbow terminator.
E. Tool Set: Shotgun hot stick with energized terminal indicator, fault-indicator test tool, and
carrying case.
2.5 SOURCE QUALITY CONTROL
A. Test and inspect cables before shipping.
B. Test strand-filled cables for water-penetration resistance according to ICEA T-31-610, using a
test pressure of 5 psig.
PART 3 - EXECUTION
3.1 INSTALLATION
A. Install cables according to IEEE 576.
B. Pull Conductors: Do not exceed manufacturer's recommended maximum pulling tensions and
sidewall pressure values.
1. Where necessary, use manufacturer-approved pulling compound or lubricant that will not
deteriorate conductor or insulation.
2. Use pulling means, including fish tape, cable, rope, and basket-weave cable grips that
will not damage cables and raceways. Do not use rope hitches for pulling attachment to
cable.
C. Install exposed cables parallel and perpendicular to surfaces of exposed structural members and
follow surface contours where possible.
D. Support cables according to Division 26 Section "Common Work Results for Electrical."
E. Install "buried-cable" warning tape 12 inches above cables.
F. Install terminations at ends of conductors and seal multiconductor cable ends with standard kits.
G. Install separable insulated-connector components as follows:
1. Protective Cap: At each terminal junction, with one on each terminal to which no feeder
is indicated to be connected.
2. Portable Feed-Through Accessory: Three.
3. Standoff Insulator: Three.
Contract 44577 KW Annex – Rev. D 44577-CSI-SPEC-001 260513-4