SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
1. All Pipe Sizes: Insulation shall be the following:
a. Mineral-Fiber, Preformed Pipe, Type I or II: 1 inch thick.
D. Hot Service Vents:
1. All Pipe Sizes: Insulation shall be the following:
a. Mineral-Fiber, Preformed Pipe, Type I or II: 1 inch thick.
3.16 OUTDOOR, ABOVEGROUND PIPING INSULATION SCHEDULE
A. Hydronic Water:
1. All Pipe Sizes: Insulation shall be the following:
a. Mineral-Fiber, Preformed Pipe Insulation, Type I: 3 inches thick.
3.17 INDOOR, FIELD-APPLIED JACKET SCHEDULE
A. Install jacket over insulation material. For insulation with factory-applied jacket, install the
field-applied jacket over the factory-applied jacket.
B. If more than one material is listed, selection from materials listed is Contractor's option.
C. Ducts and Plenums, Concealed: None.
D. Ducts and Plenums, Exposed: None.
E. Piping, Concealed: None.
F. Piping, Exposed below 8 ft above the finished floor, except flexible elastomeric insulation:
Stainless Steel, Type 304 Smooth 2B Finish: 0.016 inch thick.
3.18 OUTDOOR, FIELD-APPLIED JACKET SCHEDULE
A. Install jacket over insulation material. For insulation with factory-applied jacket, install the
field-applied jacket over the factory-applied jacket.
B. If more than one material is listed, selection from materials listed is Contractor's option.
C. Piping, Exposed:
1. Stainless Steel, Type 304, Stucco Embossed with Z-Shaped Locking Seam: 0.016 inch
thick.
END OF SECTION 230700
Contract 44577 KW Annex - Rev. D 44577-CSI-SPEC-001 230700 - 21