SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
13. Weld Filler Material(s) (WFM): The material (metal and nonmetal) to be added when
making a weld, braze or bond joint
14. Weld Maps: Formal sketches, design drawings, or shop drawings that show the location
of welds in a system, so that documentation (i.e., Certified Material Test Reports, Welder
Identification, and Weld Examination Records) can be traced to the weld it represents.
15. Welder Performance Qualification (WPQ): The record which documents a Welder's successful
completion of a performance qualification test and establishes the range of variables
the Welder is qualified for.
16. Welding Procedure Specification (WPS): a document providing in detail the required variables
for a specific welding application to assure repeatability by properly trained welders
and welding operators
17. Work Package (WP): Consists of a collection of forms, documents, procedures, work instructions,
etc. necessary to support a certain scope of work.
18. WQ&I: Welder Qualification and Inspection
1.6 PERFORMANCE REQUIREMENTS
A. General Conditions for the General Service Compressed Air Piping system:
1. Compressed air system: Normal operating pressure at 135 psig, maximum.
2. Compressed air system: Normal design pressure of 150 psig.
3. Instrument air system: Normal operating pressure at 100 psig, maximum.
4. Instrument air system: Normal design pressure of 125 psig.
5. Normal minimum operating temperature at 65 deg F.
6. Normal maximum operating temperature at 80 deg F.
7. Fluid properties are the same as clean air at 68 deg F.
8. Piping Code: ASME B31.3, Normal Service.
B. Manufacturer Seismic Qualification Certification: Submit certification that General Service
Compressed Air Piping, accessories, and components will withstand seismic forces defined in
Section 220548, Vibration and Seismic Controls for Plumbing Piping and Equipment. Include
the following:
1. The term "withstand" means "the unit will remain in place without separation of any parts
from the device when subjected to the seismic forces specified."
2. Basis for Certification: Indicate whether withstand certification is based on actual test of
assembled components or on calculation.
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221513 - 8