SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
13. Weld Maps: Formal sketches, design drawings, or shop drawings that show the location
of welds in a system, so that documentation (i.e., Certified Material Test Reports, Welder
Identification, and Weld Examination Records) can be traced to the weld it represents.
14. Welder Performance Qualification (WPQ): The record which documents a Welder's successful
completion of a performance qualification test and establishes the range of variables
the Welder is qualified for.
15. Welding Procedure Specification (WPS): a document providing in detail the required variables
for a specific welding application to assure repeatability by properly trained welders
and welding operators
16. Work Package (WP): Consists of a collection of forms, documents, procedures, work instructions,
etc. necessary to support a certain scope of work.
17. WQ&I: Welder Qualification and Inspection
1.6 PERFORMANCE REQUIREMENTS
A. General Design Requirements and Conditions for the Low Pressure Air Purge and Process Condensate
Drain Piping System:
1. Normal operating pressure at 7 psig, maximum.
2. Normal design pressure of 10 psig.
3. Normal operating temperature at 68 deg F.
4. Normal design temperature at 100 deg F.
5. Normal operating flow rate at 150 scfm, maximum.
6. Fluid properties are the same as Air at 68 deg F.
7. Piping Code Low pressure system: ASME B31.3, Normal Service.
B. Manufacturer Seismic Qualification Certification: Submit certification that Low Pressure Air
Purge Piping, accessories, and components will withstand seismic forces defined in Section
220548, Vibration and Seismic Controls for Plumbing Piping and Equipment. Include the
following:
1. The term "withstand" means "the unit will remain in place without separation of any parts
from the device when subjected to the seismic forces specified."
2. Basis for Certification: Indicate whether withstand certification is based on actual test of
assembled components or on calculation.
3. All pipe installation isometrics and vendor specific data necessary for pipe stress analysis
(including flange leakage analysis data) shall be supplied by the Seller to the Buyer for
review 30 days prior to scheduled installation date.
Contract 44577 KW Annex - Rev. E 44577-CSI-SPEC-001 431510 - 8