SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
1.5 DEFINITIONS
A. Refer to Section 011100, Summary of Work, for definition of general requirements that apply to
all specification sections prepared for this Project.
B. Specific definition applicable to this section include:
1. Buyer: the contractor responsible for managing the design, procurement, and construction
of the K-West Basin Modification Annex Project.
2. Seller: Contracted fabricator, vendor, or subcontractor performing work to the contract
drawings, data sheets, and technical specifications.
3. Certificate of Conformance: A document signed or otherwise authenticated by an authorized
individual certifying the degree to which items or services meet specified requirements.
4. Certified Test Report (CTR): A written signed document, approved by qualified personnel
that contains sufficient data and information to verify the actual properties of items
and the actual results of all required tests.
5. Certified Weld Inspector (CWI): Personnel performing visual examination of welds certified
per the employers written practice in accordance with ASNT-TC-1A.
6. High-Pressure Compressed-Air Piping: System of compressed-air piping and specialties
operating at pressures between 100 and 125 psig, located between the system air compressor
and the system air dryer.
7. Instrument Air Piping: System of instrument-air piping and specialties operating at pressures
of 125 psig or less and located downstream of the system air dryer.
8. MSDS: Material Safety Data Sheet
9. Performance Qualification Test (PQT): Standard performance test(s) which a Welder
shall successfully pass in order to be qualified to weld. The requirements for these tests
are based on a qualified Welding Procedure Specification and establish a specific range
of essential variables the Welder is qualified for.
10. Pressure, Leak Test: The static pressure, acting in the direction of the operating pressure
(positive or negative), used for establishing leakage rates. This pressure usually exceeds
the maximum operating pressure of the item being tested, but does not exceed structural
capability pressure.
11. Procedure Qualification Record (PQR): Written documentation of the qualification of a
Welding Procedure Specification by examination and testing of physical weld specimens
made using the Welding Procedure Specification
12. Storage (Holding) Ovens: Vented and temperature controlled ovens in which welding filler
materials are stored after opening the manufacturer-supplied container
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221513 - 7