SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
1.7 PROJECT CONDITIONS
A. Facility conditions
1. Equipment that is to be located indoors will be in a temperature controlled industrial type
location.
2. Facility interior ambient conditions are 65 to 80 °F.
3. Facility exterior ambient conditions are -27 to 110 °F.
4. Facility elevation is 660 ft above mean sea level.
B. Interruption of Existing Service(s): Do not interrupt services to facilities occupied by the Buyer or
others unless permitted under the following conditions and then only after arranging to provide
temporary service according to requirements indicated:
1. Notify Buyer no fewer than two days in advance of proposed interruption of facility
service(s).
2. Do not proceed with interruption of facility service(s) without Buyer's written
permission.
1.8 COORDINATION
A. Coordinate interfacing service connections with other service connections.
1. Process systems service connections are specified in Section 011100, Summary of Work.
2. Electrical power connections (if required) are specified in Section 260519, Low-Voltage
Electrical Power Conductors and Cables.
1.9 EXTRA MATERIALS
A. Furnish extra materials described below that match products installed and that are packaged with
protective covering for storage and identified with labels describing contents.
1. One set of tools required for installation and maintenance.
1.10 DELIVERY, STORAGE AND HANDLING
A. See Section 016600, Material and Equipment Storage, and Handling, for general delivery storage
and handling requirements.
B. Individual pipe spools that are delivered to the fabrication site shall be cleaned in accordance with
Part 3.1.A and capped with chloride/halogen free plastic caps.
C. Pipe spools shall be labeled with the full fill line numbers in accordance with Section 220553,
Identification for Plumbing Piping and Equipment.
Contract 44577 KW Annex - Rev. E 44577-CSI-SPEC-001 431510 - 9