SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System January 2012
1.10 DELIVERY, STORAGE AND HANDLING
A. See Section 016600, Material and Equipment Storage, and Handling, for general delivery storage
and handling requirements.
B. Individual compressed air components that are delivered to the fabrication site shall be cleaned
in accordance with Part 3.1.A and capped with chloride/halogen free plastic caps.
C. Compressed air components shall be labeled with the full fill line numbers in accordance with
Section 220553, Identification for Plumbing Piping and Equipment.
1.11 WARRANTY
A. Special Warranty: Manufacturer's standard form in which manufacturer agrees to repair or
replace components of air compressor or air dryer equipment that fails in materials or
workmanship within specified period.
1. Compressor or Air Dryer Warranty Period: Five years from date of Substantial
Completion.
PART 2 - PRODUCTS
2.1 GENERAL REQUIREMENTS FOR PACKAGED AIR COMPRESSOR, RECEIVER TANKS
AND DESICCANT DRYER
A. General Description Compressor Skid: Factory-assembled, -wired, -piped, and -tested; electricmotor-driven;
air-cooled; continuous-duty single stage lubricated rotary screw air compressor,
oil separator, water separator and compressor mounted wet air receiver tank that delivers air of
quality equal to intake air.
B. General Description Heated Purge Desiccant Dryer: Factory-assembled, -wired, -piped, and -
tested; electric-motor-driven blower with heater; that deliver air of quality equal to or less than
-40 deg F dew point air.
C. General Description Air Receiver: Steel tank constructed according to ASME Boiler and
Pressure Vessel Code: Section VIII, Division 1.
1. Pressure Rating: At least as high as highest discharge pressure of connected compressor,
and bearing appropriate code symbols.
2. Interior Finish: Corrosion-resistant coating.
3. Accessories: Include safety valve, pressure gage, electric automatic drain and manual
isolation valve.
D. General Description Mounting Frames: Fabricate mounting and attachment to compressor skid,
receiver and desiccant dryer skid with reinforcement strong enough to resist packaged
equipment movement during a seismic event when base is anchored to building structure.
E. General Description Electrical Termination Panels: Comply with NEMA ICS 2 and UL 508
Contract 44577 KW Annex – Rev. E 44577-CSI-SPEC-001 221519 - 4