SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
Hardware Points Software Points
Point Name AI AO BI BO AV BV Sched Trend Alarm Show On Graphic
Fan Status × ×
Fan Start/Stop × × ×
Environmental Index × ×
Percent of Time Satisfied × ×
Schedule ×
Heating Setpoint × ×
Cooling Setpoint × ×
High Zone Temp ×
Low Zone Temp ×
Filter Change Required ×
Fan Failure ×
Fan in Hand ×
Fan Runtime Exceeded ×
Totals 3 1 2 1 2 0 1 9 6 9
1.9 ECRT-AHU-504
Total Hardware ( 7 ) Total Software ( 18 )
A. Run Conditions - Scheduled:
1. The unit shall run according to a user definable time schedule in the following modes:
2. Occupied Mode: The unit shall maintain
a. A 80°F (adj.) cooling setpoint
b. A 65°F (adj.) heating setpoint.
B. Alarms shall be provided as follows:
1. High Zone Temp: If the zone temperature is greater than the cooling setpoint by a user
definable amount (adj.).
2. Low Zone Temp: If the zone temperature is less than the heating setpoint by a user
definable amount (adj.).
C. Zone Setpoint Adjust:
1. The occupant shall be able to adjust the zone temperature heating and cooling setpoints at
the zone sensor.
D. Fan:
1. The fan shall run anytime the unit is commanded to run, unless shutdown on safeties.
E. Coil Valve:
1. The controller shall measure the zone temperature and modulate the coil valve to
maintain its heating or cooling setpoint.
Contract 44577 KW Annex - Rev. D 44577-CSI-SPEC-001 230993 - 11