SECTION 033000 - CAST-IN-PLACE CONCRETE

Sludge Treatment Project Engineered Container Retrieval and Transfer System December 2011
PART 3 - EXECUTION
3.1 PREPARATION
A. Protect benchmarks and survey control points from disturbance during construction.
B. Protect existing site improvements to remain from damage during construction.
1. Restore damaged improvements to their original condition, as acceptable to Buyer’s
Technical Representative.
3.2 TEMPORARY EROSION CONTROL
A. Provide temporary erosion-control measures to prevent soil erosion and discharge of soilbearing
water runoff or airborne dust to adjacent areas and walkways according to Site
Drawings and requirements of authorities having jurisdiction.
B. Inspect, maintain, and repair erosion-control measures during construction until final grades are
established and stabilized.
C. Restore and stabilize areas disturbed during removal of erosion control measures.
3.3 EXISTING UTILITIES
A. Locate, identify, disconnect, and seal or cap utilities indicated to be removed or abandoned in
place.
1. Arrange with Buyer’s Technical Representative to shut off indicated utilities.
B. Interrupting Existing Utilities: Do not interrupt utilities serving facilities unless permitted under
the following conditions and then only after arranging to provide temporary utility services
according to requirements indicated:
1. Notify Buyer’s Technical Representative not less than five (5) days in advance of
proposed utility interruptions.
2. Do not proceed with utility interruptions without Buyer’s Technical Representative’s
written permission.
3.4 CLEARING AND GRUBBING
A. Remove obstructions, shrubs, and other vegetation to permit installation of new construction.
B. Fill depressions caused by clearing and grubbing operations with approved fill material unless
further excavation or earthwork is indicated.
Contract 44577 KW Annex - Rev. D 44577-CSI-SPEC-001 311000 - 2