Protege System Controller Reference Manual

Trouble Zone Type Third Area Assignment
When a trouble zone is assigned to an area the zone must be programmed with the type of trouble zone
(Trouble Silent, Trouble Bell etc).
CP001:01 Type 3
None
Use the [1] and [3] keys to scroll the available zone types that can be assigned to the trouble zone. For more
information about the list control data entry refer to the section List Control Data Entry (see page 344).
Trouble Zone Fourth Area Assignment
The trouble zone must be assigned to an area for it to perform any function in the system. By default ALL
trouble zones are assigned to the predefined trouble area which is the last programmable area in the system. A
trouble zone can be assigned in up to 4 different areas. A trouble zone can perform a different function in each
area.
CP001:01 Area 4
None
Use the [1] and [3] keys to scroll the available areas that can be assigned to the trouble zone. For more
information about the list control data entry refer to the section List Control Data Entry (see page 344).
Trouble Zone Type Fourth Area Assignment
When a trouble zone is assigned to an area the zone must be programmed with the type of trouble zone
(Trouble Silent, Trouble Bell etc).
CP001:01 Type 4
None
Use the [1] and [3] keys to scroll the available zone types that can be assigned to the trouble zone. For more
information about the list control data entry refer to the section List Control Data Entry (see page 344).
Zone Type
To access the Zone Type programming menu login using a valid installer code and then select [MENU, 4, 2, 2].
The screen displays "Zone type to modify" as shown in the following example.
Zone Type to
modify: ZT001
Every time you press the [ENTER] key, the next screen appears. The different screens are described in the
following sub-sections.
Zone Type Name
If the selected zone type has a name associated (some zone types do not have a name associated with them)
the name programming screen will be shown.
ZT001 Name
Delay
To scroll zone types by name use the [] and [] keys. To modify or enter a new name for the selected zone
type use the keypad as explained in section Entering Text and Names (see page 341) and press [ENTER].
By default the zone name will be prefixed by an '*' this indicates that the name is an editable name in the
system.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 101