Protege System Controller Reference Manual

• Disabled the area will arm regardless of the count value.
Option 8 - Validate Schedule Each Minute
• Enabled the area will verify that the programmed schedule has not changed or the area has not be
disarmed when it should be armed. This will occur every one minute period.
• Disabled the area does not check the schedule each minute. If the schedule is programmed the schedule is
validated when the start time is reached and when the end time is reached and does not take in to account
the control of the area outside these times.
Area Special Options
The special options include a number of specific options that may be required in special circumstances.
AR001 Special
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 – Defer Automatic Arming
• Enabled the area will begin a defer arming cycle prior to starting to arm the area when the area is set to
automatically arm on schedule.
• Disabled the area will arm normally.
Option 2 – Force Arm Card Reader
• Enabled the area will force arm the area when the arming process is started by a card reader.
• Disabled the area will arm normally.
Option 3 – Disable Exit PGM on Stay
• Enabled the area will not activate the Exit PGM when the area is stay armed.
• Disabled the area will activate the Exit PGM if programmed when the area is stay armed.
Option 4 – Clear Alarm Memory on Arm
• Enabled the area clear all alarm memory when the area is armed.
• Disabled the area will arm normally.
Option 5 – Early/Late Arm Report
• Enabled the area will generate Early to Arm and Late to Arm reportable events according to the normal
operating schedule (see above).
• Disabled the area will not generate these events.
Option 6 – Early/Late Disarm Report
• Enabled the area will generate Early to Disarm and Late to Disarm reportable events according to the
normal operating schedule (see above).
• Disabled the area will not generate these events.
Option 7 and 8 – Reserved
• Reserved do not modify
Enabling/disabling or modifying the settings of reserved options is not recommended.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 129