Protege System Controller Reference Manual

Option 5 - User Counting
• Enabled the users that access this area will be counted using the area counting function.
• Disabled the area will not perform any counting.
Option 6 - Arm On Count Reaching 0
• Enabled the area will arm when the count in the area reaches the terminal 0 count.
• Disabled the area will not perform any function on the count reaching 0.
Option 7 - Report Entry Zones Immediately
• Enabled the area will report the activation of an entry zone immediately event though the alarm may be in an
entry delay operation.
• Disabled the area will report entry zones if the entry delay times out and the alarm activates.
Option 8 - Clear Area Count On Arming
• Enabled the area will clear the count setting in the area to 0 when the area is armed.
• Disabled the area does not change the count setting when it is armed.
Area Arming Options
Arming options for the area include the settings for the stay, force and instant arming options as well as some
count options and banking industry options.
AR001 Arming
[--------]
To modify options, use the keypad as explained in section Entering Data Options (see page 344).
Option 1 - Stay Arm
• Enabled the area can be stay armed.
• Disabled the area can not be stay armed.
Option 2 - Force Arm
• Enabled the area can be force armed.
• Disabled the area can not be force armed.
Option 3 - Instant Arm
• Enabled the area can be instant armed.
• Disabled the area can not be instant armed.
Option 4 - Prevent Arming If Trouble Condition
• Enabled the area will be prevented from arming if a trouble condition is present in the system.
• Disabled the area will arm regardless of the trouble condition.
Option 5 - Banking Vault Control Area
• Enabled the area is used to control a vault area.
• Disabled the does not control a vault area.
Option 6 - Banking Vault Dual Control Area
• Enabled the area will require that two users control this area when enabled as a vault control area. This
feature will not function unless the area has option 5 enabled.
• Disabled the area will require only one code to control the vault control functions.
Option 7 - Prevent Arming if Count is Not Zero
• Enabled the area will be prevented from arming if the count value for the area is greater than 0.
128 PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE