Protege System Controller Reference Manual

Service Mode
The service mode determines how this service operates with the system controller. By default a service is set to
start with the operating system. Setting a service to Start With The Operating System (Start With O/S) allows the
service to operate automatically, if the system controller is reset or restarts the service will automatically restart
with the operating system. To only start and stop the service manually select the manual option.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select the operating mode
displayed. For more information about the list control data entry refer to the section List Control Data Entry (see
page 344).
Contact ID Client Code
The contact ID client code is used to identify the system to the remote monitoring company when a report is
generated. The client code will accept hexadecimal numbers however this will be dependent on the ability of the
receiver and should be verified before configuration.
SV001 Client
code: 0000
Type the appropriate 4 digit client code, after each digit you must press [] and [] to move to the next digit.
When the desired client code is entered, press [ENTER] to save the programmed setting and move to the next
screen. For more information about hexadecimal data entry refer to the section Hexadecimal Data Entry (see
page 343).
PABX Phone Number
The PABX phone number is dialed to gain an outside line if the system is connected to a internal phone
extension. The PABX phone number can also be programmed with a schedule in the case that between certain
times the phone line is directly connected with an outside line.
SV001 PABX
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 344).
Phone Number One
The primary phone number will be dialed by the contact ID service when it first is initiated to report an event. The
sequence of telephone number dialing is limited by the number of dialing attempts and the method of dialing
that is configured (alternate or sequential).
SV001 Phone 1
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select the phone number
displayed. To program a phone number select [MENU, 4, 7, 2]. For more information about the list control
data entry refer to the section List Control Data Entry (see page 344).
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 155