Protege System Controller Reference Manual

24HR Disabling
The Protege System continually checks zones and trouble zones for a tamper condition regardless of the armed
status of the area. The 24Hr processing monitors trouble zones as well as tamper and shorts on zones within
the selected area. This allows the tamper zones to generate an alarm even if the area is disarmed. To disable
the 24Hr processing of an area, you must have access to the area and the user must have the option to access
the 24Hr Processing enabled.
• Access the area status display screen as explained in section Area Status Display (see page 15). Using the
scroll keys [ ] select the area that you want to disarm.
*Area 001
is DISARMED
• From the Area Status screen, press the [] key to select the 24Hr Status screen.
*Area 001
24HR Enabled
• From the Area 24Hr Status screen, press the [DISARM] key to disarm/disable the 24Hr processing in the
selected area. Pressing the [DISARM] key starts the disable/disarming process.
*Area 001
24HR Busy
• When the 24Hr disable/disarming process is completed the 24Hr area status will change to "24Hr
Disabled".
*Area 001
24HR Disabled
• Press the [] key to return to the area status display.
• Press the [CLEAR] key to exit.
i
To disarm the 24Hr processing of the selected area, you must be able to access it, refer to the Area
Security (see page 16). The user must have the access 24Hr Processing Option enabled.
The Protege System protects the area programming by preventing ANY programming to be done
when either the Area or the 24Hr processing of an area is enabled. You must always disable the 24Hr
processing and disarm an area before the area can be programmed.
Area Group Arming
Area group processing allows you to arm or disarm a group of areas rather than one area at a time. The area
group controlled is the area group assigned to the keypad used to access the system. To arm the area group
the user must be able to access ALL the areas in the area group. The user must have the access area group
option enabled to access the area group function.
• Access the area status display screen as explained in section Area Status Display (see page 15).
*Area 001
is DISARMED
• From the Area Status screen, press the [] key to select the Area group control screen.
Press [ARM] or
[DISARM] to
The screen will scroll between the screen above and below prompting the user to press the [ARM] or
[DISARM] key to control the area group that is shown.
control group
*Area Group 001
• From the Area Group Control screen, press the [ARM] key to arm the selected area group. Pressing the
[ARM] key starts the arming process for each area in the area group.
• When the area group arming process is completed the display will return to the area group control screen.
• Press the [] key to return to the area status display.
• Press the [CLEAR] key to exit or the [MENU] key to select another menu option or function.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 19