Protege System Controller Reference Manual

Reader Expander
The reader expander selection programs the elevator to send the activation of floor information and floor
selection to the reader expander programmed. You must also set the port number in the next screen to the
appropriate port driving this elevator.
EL001 Reader
None
Use the [1] and [3] keys to scroll the reader expanders that are available and press [ENTER] to select the
expander displayed. For more information about the list control data entry refer to the section List Control Data
Entry (see page 344).
Reader Port
The reader port selection programs the elevator to communicate on this port with the expander number
selected above. You must also set the reader expander number in the previous screen.
EL001 Port
None
Use the [1] and [3] keys to scroll the reader port and press [ENTER] to select the port displayed. For more
information about the list control data entry refer to the section List Control Data Entry (see page 344).
Floor Open Time
The floor open time configures the amount of time that a floor will be activated for when it has been selected or
the amount of time the floor relay will be activated for when the user has presented a card.
EL001 Open
time: 005 secs
To modify the Floor open time (000 to 255 Seconds), use the keypad as explained in section Entering Decimal
Numbers (see page 341) and press [ENTER].
Destination Select Time
The destination select time configures the amount of time that user has to select a floor when they present their
card.
EL001 Select
time: 005 secs
To modify the floor select time (000 to 255 Seconds), use the keypad as explained in section Entering Decimal
Numbers (see page 341) and press [ENTER].
Floor Configuration
Each floor in an elevator can be assigned options, an unlock schedule and an area. These options configure
how the floor will function. You must select the floor to modify for the elevator that you are programming.
EL001 Floor to
modify: FL001
Type the appropriate 3-digit floor number or use the [] and [] keys to scroll the available floors for the
elevator. When the desired floor number appears on the screen, press [ENTER] to program the selected floor.
PRT-CTRL-SE Protege System Controller Reference Manual | PRT-CTRL-SE 145